STC MSC Roof Panel

STC-MSC Inset Gable Height Change w Field Bend Vertical Leg

* FIELD CUT BOTTOM OF WALL PANELS TO MATCH ROOF SLOPE. PROVIDE AIR GAP OF 1/4" MIN. AT BOTTOM OF PANEL TO AVOID CORROSION.

INSIDE CLOSURE HEIGHT CHANGE TRIM TOP (GHMTF) TRI-BEAD TAPE SEALER

HEIGHT CHANGE ANGLE (A-20-H) * WALL PANEL

BL

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING) (SEE INSET DETAIL)

#12-14 X 1 1/4" (6" C.C. for CS PANEL) (12" C.C. for AP PANEL)

1/4-14 X 1 1/4" WT (12" C.C.)

***

RAKE SUPPORT (A-20-S)

PRE-TAPED THERMAL SPACER (NOT BY CHIEF)

STC/MSC ROOF PANEL (FIELD FORM 3" VERTICAL LEG TO FIT FINAL DIMENSION)

*** DRAFTING NOTE: THERMAL SPACER TO BE USED WITH NO INSULATION.

1

4 "

PURLIN

2"

HEIGHT CHANGE TRIM BOTTOM (GHMBF)

#12-14 X 1" PANCAKE HEAD (2 EACH PURLIN)

** IT IS IMPORTANT THAT FASTENERS ARE INSTALLED THROUGH THE CENTER OF THE SLOTTED HOLES OF THE RAKE SUPPORT.

**1/4-14 X 1 1/4" SHOULDER (24" C.C.)

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING)