Composite Material, Rigid Board, R-Seal

STC-MSC Rigid Roof Ridge

NOTES: * For screw spacing refer to Ridge detail in the MSC/STC Roof Panel Erection Manual.

NOTCH ANGLE TO AVOID INTERFERENCE WITH BACK-UP PLATE SCREWS

1 1 2 "

** 24" STC - Pre-Cut Tri-Bead Tape Mastic. 24" MSC - Tri-Bead Tape Mastic from roll. 18" MSC/STC - Tri-Bead Tape Mastic from roll.

4"

RAKE SUPPORT

DRAFTING NOTE: **** Adjust panel length to compensate for composite roof thickness. Hold 4" clearance shown from the TOP of the composite . ***Insulation is representative. Erector shall refer to insulation manufacturer’s installation information for further details/direction. The erector is responsible for providing the final solution for installation, air tightness, and performance of the liner insulation system.

7"

ROOF PANEL SUPPORT RIGID CONTINUOUS INSULATION (NOT BY CHIEF)

L RIDGE

GABLE ANGLE CLEARANCES

RIDGEL

* 1/4-14 X 7/8" WT

** TRI-BEAD TAPE MASTIC OUTSIDE CLOSURE TRI-BEAD TAPE MASTIC

ROOF CAP (RCL)

4"

X"

PANEL CLIP W/ FASTENERS (SEE ROOF PANEL PLAN)

****

PANEL OVERHANG FROM PURLIN

PRE-GLUED THERMAL SPACER (NOT BY CHIEF)

MSC ROOF PANEL

TOP OF PURLIN

TOP OF PURLIN

1'-0" **** Special Panel Clearance from Ridge at Top of Purlin.

BEARING PLATE (HW7500) (2) #12-14 X 1" PANCAKE HEAD (2'-0" C.C.)

*** ___" RIGID CONTINUOUS INSULATION (NOT BY CHIEF)

BACK-UP PLATE

PURLIN

RIDGE PAN TRIM (SPT-x) (PW)

1/4-14 X 1 1/4" WT (8 PER PANEL)