Composite Material, Rigid Board, R-Seal

AP Metal Bldg Walkdoor-PA-SF Rigid Wall

AP Panel - Rigid Board Insulation in Wall - Metal Building Walkdoor - Pre-Assembled (by Chief) or Self-Framing Not by Chief Refer to Order Documents for Doors by Chief

NOTES: ·

#12-14 X ____"

Special Fastener =

·

Rigid Continuous Insulation thickness =

X"

· Rigid Continuous Insulation and vapor retarder are not by Chief. · Insulation is representative. Erector shall refer to insulation manufacturer’s installation information for further details/direction. The erector is responsible for providing the final solution for installation, air tightness, and performance of the liner insulation system. · The details shown below are typical. · Not all details may apply. · Specific details for additional features will be provided for complete installation instructions. · Drill Ø1/8" holes for Blind Rivets. · Rivets spaced at 7'-0" C.C. are temporary fasteners. · LCT1 or LCT2 used with Liner/Backer. Refer to Liner or Partition Panel Dwg. · Provide air gap of 1/4" min. at bottom of panels to avoid corrosion.

4 1/4"

HEADER TRIM WITH TROUGH (HTT)

NOTCH WALL PANEL FOR EXTENSION OF TRIM.

JAMB TRIM (JTA)

TRIM DETAIL AT CORNER

BL

1/8" X 3/8" BLIND RIVET (7'-0" C.C.) (TYP.)

RIGID CONTINUOUS INSULATION (NOT BY CHIEF)

CEE HEADER

LINER COVER TRIM (LCT1 OR LCT2) (Field modify as req'd)

OPENING WIDTH

WALL PANEL

NOMINAL DOOR OPENING

ZEE GIRT

INSIDE CLOSURE

JAMB

#12-14 X 1" PANCAKE HEAD (36" C.C.) SPECIAL PLATE (REFER TO FRAMING PLANS FOR PIECE MARKS) (PL-x) LINER COVER TRIM (LCT1 OR LCT2) (Field modify as req'd)

#12-14 X 1" PANCAKE HEAD (12" C.C.)

DOOR FRAME

SPECIAL FASTENER (12" C.C.)

SPECIAL TRIM (SPT-x)

BL

JAMB TRIM (JTA)

1

4 "

WALL PANEL SPECIAL FASTENER (12" C.C.) SHEETING SUPPORT (SSP) RIGID CONTINUOUS INSULATION (NOT BY CHIEF)

1/4-14 X 7/8" (12" C.C.)

HEADER TRIM (HTT) 1/8" X 3/8" BLIND RIVET (7'-0" C.C.) SPECIAL TRIM (SPT-x) #12-14 X 1" PANCAKE HEAD (7'-0" C.C.)

***1/8"-3/4"

1/2"

DOOR FRAME

*** Locate JTA/HTT trim assembly to cover door frame avoiding interference with latch, door and hinges.

1/4-14 X 7/8" (12" C.C.)

WALKDOOR HEADER

WALKDOOR JAMB TRIM DETAILS