MVF MVP Roof Panel

MVF-MVP Gable Lead End Height Change w Cut Roof Panel

* Field cut bottom of wall panels to match roof slope. Provide air gap of 1/4" min. at bottom of panel to avoid corrosion.

ROOF PANEL CUT BACK DIM.

CLIP LOCATION FROM B

L

BL

HEIGHT CHANGE TRIM BOTTOM (GHVB) HEIGHT CHANGE TRIM TOP (GHVT)

2 1 4 "

*WALL PANEL INSIDE CLOSURE #12-14 X 1 1/4"

1 1 2 "

DOUBLE BEAD TAPE MASTIC 1/4-14 X 1 1/4" WT (6" C.C.)** TAPE MASTIC (2) #12-14 X 1 1/4" (EACH CLIP) WALL COLOR

(6" C.C. for CS PANEL) (12" C.C. for AP PANEL)

MVF/MVP ROOF PANEL RAKE ANGLE (A-20-B)

***

1

4 "

PRE-GLUED THERMAL SPACER (NOT BY CHIEF)

PANEL CLIP RAKE ANGLE (A-20-L)

PANEL CLIP w/FASTENERS (REFER TO ROOF PANEL PLAN)

(2) #12-14 X 1 1/4"

DOUBLE BEAD TAPE MASTIC

**NOTE: This fastener must not hit the purlin. ***DRAFTING NOTE: Thermal spacer to be used with no insulation.

PURLIN

#12-14 X 1 1/4" (2 EACH PURLIN) (WALL COLOR)