MVF MVP Roof Panel

MVF-MVP Outset Gable Tail End Height Change w Cut Roof Panel and Panel Below-Thermal Spacer

* Field cut bottom of wall panels to match roof slope. Provide air gap of 1/4" min. at bottom of panel to avoid corrosion.

PURLIN

PURLIN CLOSURE AT RIDGE IS TO BE FIELD CUT AND FASTENED TOGETHER WITH (2) 1/8" X 3/8" BLIND RIVETS.

PURLIN CLOSURE (GPC2 OR GPC3) (TYP) (2) PURLIN CLOSURE CLIPS (GCC1) AT EACH PURLIN CLOSURE (2) #12-14 X 1 1/4" EACH CLIP (2) 1/8" X 3/8" BLIND RIVETS (EACH CLIP)

ROOF PANEL CUT BACK DIM. CLIP LOCATION FROM B

CLOSURE CLIPS (GCC-1) (TYP.)

**NOTE: This fastener must not hit the purlin.

PURLIN CLOSURE (TYP.)

L

HEIGHT CHANGE TRIM BOTTOM (GHVB) HEIGHT CHANGE TRIM TOP (GHVT)

*WALL PANEL INSIDE CLOSURE #12-14 X 1 1/4"

BL

2 1 4 "

DOUBLE BEAD TAPE MASTIC 1/4-14 X 1 1/4" WT (6" C.C.)** TAPE MASTIC (2) #12-14 X 1 1/4" (EACH CLIP) WALL COLOR

PURLIN

(6" C.C. for CS PANEL) (12" C.C. for AP PANEL) RAKE ANGLE (A-20-L)

1 1 2 "

(2) 1/8" X 3/8" BLIND RIVETS (TYP.)

(2) #12-14 X 1 1/4"' PER CLOSURE

MVF/MVP ROOF PANEL RAKE ANGLE (A-20-B)

TOP VIEW

1

4 "

THERMAL SPACER

(NOT BY CHIEF)

#12-14 X 1 1/4" (2 EACH PURLIN) (WALL COLOR)

NOTE: · Purlin closure is to be field cut between eave struts and purlins. · Closure clips may need to be field cut to fit in purlin and staggered so #12-14 X 1 1/4" fasteners don't interfere.

PANEL CLIP w/FASTENERS (REFER TO ROOF PANELING PLAN)

DOUBLE BEAD TAPE MASTIC

#12-14 X 1 1/4" (GA) (2 EACH PURLIN)

EAVE STRUT

RAKE ANGLE (A-20) HEIGHT CHANGE RAFTER

(2) #12-14 X 1 1/4" (2) 1/8" X 3/8" BLIND RIVETS PURLIN CLOSURE CLIPS (GCC1)

PURLIN CLOSURE (GPC__) (PURLIN CLOSURE CLIPS NOT SHOWN)

1/4-14 X 7/8" (12" C.C.)

PANELING CAP TRIM (SCT)

PURLIN CLOSURE INSTALLATION