Special Features

Parapet at High Side w CS Roof Panel and Nichiha Panel Not by Chief

NOTE: ·

TAPE MASTIC SENT FOR BACK-UP PANEL SIDE LAPS. WARRANTY FASTENERS SENT FOR BACK-UP PANEL.

Field notch the hems 2" to allow for the trim to lap. Leave a two inch space between the cleats at the connection of the parapet cap trim. Apply a 1/4" bead of Sikalastomer-511 and install 10 blind rivets at each joint.

DRAFTING: DIMENSION HORIZ. LEG OF CAP TRIM. HAVE PM VERIFY DIM. WITH BLDR.

HORIZONTAL LEG OF PARAPET CAP TRIM

·

1

·

BL

PARAPET GIRT SPECIAL PARAPET CAP TRIM (SPT-X) 1/4-14 X 1 1/4" WT (6" C.C.) (TYP) OUTSIDE CLOSURE 1/4-14 X 7/8" WT (12" C.C.)

X"

X"

#12-14 X 1 1/4" (24" C.C.)

SPECIAL PARAPET CAP TRIM (SPT-X) (OVERLAPPING)

XXX'-X"

#12 - 14 X 1 1/4" (6" C.C. for CS PANEL) (12" C.C. for AP PANEL)

SPECIAL PARAPET CLEAT (SPT-X)

SIKA-511

BACKUP PANEL INSIDE CLOSURE w/ TAPE MASTIC TOP AND BOTTOM HEIGHT CHANGE TRIM (LHTC) 1/4-14 X 7/8" WT (12" C.C.) OUTSIDE CLOSURE (2" X 3') 2 ROWS DOUBLE BEAD MASTIC TOP & BOTTOM OF OUTSIDE CLOSURE

SPECIAL PARAPET CAP TRIM (SPT-X) (UNDER LAPPING)

PANCAKE HEAD FASTENER (NOT BY CHIEF)(12" C.C.)

2"

SPECIAL PURCHASED (IF BY CHIEF)

2"

1"

* _" NICHIHA PANEL (NOT BY CHIEF)

XXX'-X"

2" GAP

SPECIAL PARAPET CLEAT (SPT-X)

CS PANEL

1

4 "

PARAPET/WALL PANEL HEIGHT CHANGE GIRT

1 1

2 "

SPECIAL PARAPET CLEAT (SPT-X)

Provide air gap of 1/4" min. at bottom of panel to avoid corrosion.

EAVE STRUT 1/4 -14 X 1 1/4" WT (6" C.C.)

1/4-14 X 1 1/4" WT (6" C.C.) PURLIN

ISOMETRIC PARAPET / FACADE CAP TRIM SPLICE DETAIL

DRAFTING USE ONLY: REMOVE EAVE STRUT OR PURLIN W/CORRESPONDING FASTENER AS REQ'D .

* NOTE: CONNECTION OF NICHIHA PANELS (NOT BY CHIEF), TO WALL PANEL IS NOT BY CHIEF.