Special Features

Parapet at Endwall w STC-MSC Gable Lead End Thermal Spacer and Nichiha Panel NBC

** IT IS IMPORTANT THAT FASTENERS ARE INSTALLED THROUGH THE CENTER OF THE SLOTTED HOLES OF THE RAKE SUPPORT. * NOTE: CONNECTION OF NICHIHA PANELS (NOT BY CHIEF), TO WALL PANEL IS NOT BY CHIEF. *** NOTE: REFER TO ISOMETRIC PARAPET FACADE CAP TRIM SPLICE DETAIL FOR INSTALLATION **** FIELD CUT BOTTOM OF BACK-UP PANELS TO MATCH ROOF SLOPE. PROVIDE AIR GAP OF 1/4" MIN. AT BOTTOM OF PANEL TO AVOID CORROSION.

DRAFTING: DIMENSION HORIZ. LEG OF CAP TRIM. HAVE PM VERIFY DIM. WITH BLDR.

TAPE MASTIC SENT FOR BACK-UP PANEL SIDE LAPS. WARRANTY FASTENERS SENT FOR BACK-UP PANEL.

HORIZONTAL LEG OF PARAPET CAP TRIM

BL

X"

#12-14 X 1 1/4" (24" C.C.)

SPECIAL PARAPET CAP TRIM (SPT-X)

*** SPECIAL PARAPET CLEAT (SPT-X)

X

1/4-14 X 7/8" WT (12" C.C.) 1/4-14 X 1 1/4" WT (6" C.C.) PARAPET GIRT

#12-14 X 1 1/4" (6" C.C. for CS PANEL) (12" C.C. for AP PANEL)

XXX'-X"

OUTSIDE CLOSURE ****BACK-UP PANEL

PANCAKE HEAD FASTENER (NOT BY CHIEF)(12" C.C.) SPECIAL PURCHASED (IF BY CHIEF)

INSIDE CLOSURE w/ TAPE MASTIC TOP AND BOTTOM HEIGHT CHANGE TRIM TOP (GHMTF) TRI-BEAD TAPE SEALER

PARAPET/WALL PANEL

* _" NICHIHA PANEL (NOT BY CHIEF)

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING) (SEE INSET DETAIL)

HEIGHT CHANGE ANGLE (A-20-H)

1/4-14 X 1 1/4" WT (12" C.C.)

1/4-14 X 1 1/4" WT (6" C.C.)

STC/MSC ROOF PANEL THERMAL SPACER

(NOT BY CHIEF)

1

4 "

1 4 "

HEIGHT CHANGE TRIM BOTTOM (GHMBF)

2"

RAKE SUPPORT (A-20-T)

** 1/4-14 X 1 1/4" SHOULDER (24" C.C.)

#12-14 X 1" PANCAKE HEAD (2 EACH PURLIN)

PURLIN

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING)

Made with FlippingBook flipbook maker