Special Features

Parapet at Endwall w STC-MSC Gable w Field Bend Leg Thermal Spacer and Nichiha Panel NBC

* NOTE: CONNECTION OF NICHIHA PANELS (NOT BY CHIEF), TO WALL PANEL IS NOT BY CHIEF.

** IT IS IMPORTANT THAT FASTENERS ARE INSTALLED THROUGH THE CENTER OF THE SLOTTED HOLES OF THE RAKE SUPPORT. *** NOTE: REFER TO ISOMETRIC PARAPET FACADE CAP TRIM SPLICE DETAIL FOR INSTALLATION **** FIELD CUT BOTTOM OF BACK-UP PANELS TO MATCH ROOF SLOPE. PROVIDE AIR GAP OF 1/4" MIN. AT BOTTOM OF PANEL TO AVOID CORROSION.

DRAFTING: DIMENSION HORIZ. LEG OF CAP TRIM. HAVE PM VERIFY DIM. WITH BLDR.

TAPE MASTIC SENT FOR BACK-UP PANEL SIDE LAPS. WARRANTY FASTENERS SENT FOR BACK-UP PANEL.

HORIZONTAL LEG OF PARAPET CAP TRIM

BL

SPECIAL PARAPET CAP TRIM (SPT-X)

X"

X

1/4-14 X 7/8" WT (12" C.C.) 1/4-14 X 1 1/4" WT (6" C.C.) PARAPET GIRT

#12-14 X 1 1/4" (24" C.C.)

*** SPECIAL PARAPET CLEAT (SPT-X)

OUTSIDE CLOSURE ****BACKUP PANEL

XXX'-X"

INSIDE CLOSURE w/ TAPE MASTIC TOP AND BOTTOM HEIGHT CHANGE TRIM TOP (GHMTF) TRI-BEAD TAPE SEALER

PANCAKE HEAD FASTENER (NOT BY CHIEF) (12" C.C.)

SPECIAL PURCHASED (IF BY CHIEF)

PARAPET/WALL PANEL * _" NICHIHA PANEL (NOT BY CHIEF) #12-14 X 1 1/4" (6" C.C. for CS PANEL) (12" C.C. for AP PANEL)

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING) (SEE INSET DETAIL)

1/4-14 X 1 1/4" WT (12" C.C.)

RAKE SUPPORT (A-20-T)

HEIGHT CHANGE ANGLE (A-20-H)

STC/MSC ROOF PANEL (FIELD FORM 3" VERTICAL LEG TO FIT FINAL DIMENSION) THERMAL SPACER (NOT BY CHIEF)

1/4-14 X 1 1/4" WT (6" C.C.)

1

4 "

1 4 "

HEIGHT CHANGE TRIM BOTTOM (GHMBF)

2"

** 1/4-14 X 1 1/4" SHOULDER (24" C.C.)

#12-14 X 1" PANCAKE HEAD (2 EACH PURLIN)

PURLIN

SIKA 511 CAULK IN LOCKFORM OF HEIGHT CHANGE TRIM TOP (BEFORE ASSEMBLING)